Blog

LADOT's neighborhood buses: what DASH covers and how to ride

DASH is the City of Los Angeles's own bus service, separate from Metro. What the routes are for, what the fare is in 2026 and how to plan a trip.

Most people who ride a bus in Los Angeles ride a Metro bus, the big orange and red fleet run by the county's transit agency. A smaller fleet runs alongside it, in colors that vary by route, and it belongs to the city itself. The Los Angeles Department of Transportation, better known for parking tickets and traffic signals, runs it under the name DASH. It is easy to miss because it does not appear on the Metro system map, yet for a resident of a hillside neighborhood, a commercial strip or a crowded downtown district, it may be the bus that actually goes where they need to be.

What DASH is

DASH began in the mid-1980s in Downtown Los Angeles as the Downtown Area Short Hop, a small-bus circulator meant to move people between nearby destinations rather than across the whole region. The idea was simple: a regional bus or train carries people long distances, and a circulator fills the gaps, running frequent short loops through areas where distances are small and stops are many. The service grew from that downtown start into neighborhood routes across the city. LADOT now runs it as part of its transit division, which also operates Commuter Express buses for peak-hour trips to and from downtown and regional job centers.

The routes follow two patterns:

  • Downtown routes, identified by letters, which circulate among Civic Center, Bunker Hill, the Financial District, South Park, the Fashion District and the Arts District. They are the most frequent DASH routes and the closest to the original idea.
  • Neighborhood routes, with names tied to a place, which loop through a community and connect it to the nearest rail station or major bus corridor. Examples include routes serving Sylmar and North Hollywood in the San Fernando Valley and Beachwood in the hills above Hollywood. Some run in both directions, and some run in one direction as a loop, with a separate counterclockwise route.

That is why DASH is "neighborhood" transit in a precise sense. A Metro bus may run ten or twenty miles down a corridor such as Wilshire or Vermont, with a stop every quarter mile or so. A DASH route typically covers a much smaller area with its own turns and loops, in a smaller vehicle that can use narrower streets. The trade is that DASH goes fewer places, but it goes deep into a particular neighborhood.

How DASH differs from Metro

The most important difference is who runs it. Metro, the Los Angeles County Metropolitan Transportation Authority, is a county-wide agency governed by its own board; its network includes the rail lines and the bus routes listed on metro.net, as described in Los Angeles County Metropolitan Transportation Authority. DASH is a city service, funded and managed by Los Angeles Department of Transportation, and it goes to the City Council for its budget. The difference shows up in a few concrete ways:

DASH (LADOT) Metro bus
Runs it City of Los Angeles County transit agency
Typical trip Short, inside a neighborhood or district Longer, across the region
Vehicles Smaller buses Full-size buses
Fare in 2026 A low flat fare (see below) $1.75, with daily and weekly caps
Planning LADOT Transit route pages Metro trip planner

The two systems are designed to work together. Many DASH routes are explicitly planned to reach a Metro rail station, so a rider can take DASH from a neighborhood to the nearest train. A resident who lives a mile from a Metro station but has no direct bus can use DASH for that first stretch and the train for the rest. Using Metro buses and trains: fares, caps and tapping explains the Metro side of that trip.

What it costs

DASH is one of the cheapest ways to travel in the city. LADOT Transit's fares page lists a flat fare for all DASH routes: 35 cents with a TAP card and 50 cents in cash in 2026, along with a 31-day pass at $18. The page has also carried fare-free periods and promotions at times, so the page itself, linked from the LADOT site at ladot.lacity.gov, is the place to confirm the current rule before a trip. TAP is the same stored-value card Metro uses, so one card can pay for both.

A worked example shows when the pass makes sense. This is a hypothetical, built on the 2026 fares above. Say a commuter takes DASH twice a day, five days a week, and works an ordinary month of 22 weekdays.

  • Rides in the month: 2 × 22 = 44.
  • Cost with TAP at 35 cents: 44 × $0.35 = $15.40.
  • The 31-day pass costs $18.

For this commuter, pay-as-you-go is cheaper. The pass breaks even at about 52 rides in a month, since $18 divided by $0.35 is roughly 51.4, so it pays off only for a rider making more than about 26 round trips. A person who uses DASH for errands on top of a commute, or who rides every day including weekends, may cross that line. The arithmetic is worth redoing if the fare changes.

Set that beside Metro's fare of $1.75 per ride with a daily cap of $5, covered in Fare capping by the numbers: what a week of Metro rides costs. A rider whose entire trip is on DASH pays a fraction of that, while a rider who combines the two pays each system's fare. LADOT also accepts transfers from some of its other passes, and the fares page lists them.

How to plan a trip

DASH routes are listed on LADOT Transit's route pages, each with a map and a timetable. A few habits make planning easier.

  1. Start with the route map. Because many routes are loops, direction matters. Read the map before you walk to a stop and note whether the bus runs clockwise or counterclockwise, since a bus that passes your stop in the wrong direction may take a long time to come back around.
  2. Check the effective date. LADOT posts timetables with an effective date, and routes were revised in January 2026. Service changes and detours are announced on the route pages, including temporary stop closures during construction. Downtown routes in particular have had stop closures tied to construction projects, so a quick look at the alerts page before a trip is worthwhile.
  3. Use a trip planner. The major map and transit apps include DASH, and Metro's own trip planner may show connections to Metro rail and buses. Because LADOT posts the DASH timetables, a mismatch between an app and the posted timetable is a reason to trust the timetable.
  4. Plan for the last trip. Each route posts its own service hours, and weekend schedules can differ from weekday ones, so check the last departure before you commit to a return trip.

Riding the Valley and the hills

The Valley and hillside routes show what the service is for. A route like Sylmar's connects a community at the northern end of the city, far from the central core, to the larger transit network. A route like North Hollywood's serves the district and the B Line terminus, so that a resident can reach the subway without a car; see North Hollywood for the district. And the Beachwood route climbs into the narrow streets below the Hollywood Sign, where a full-size bus would have trouble turning. Each of these routes exists because the street grid in its area does not suit the standard Metro design.

Who DASH is for

A circulator is built for people for whom a short trip matters more than a long one: older adults going to a clinic or senior center, students getting to a school or a rail station, workers whose shift starts a mile from the nearest train and shoppers who do not want to drive for a short errand. The low fare is deliberate. It is meant to let people use transit for short trips without paying more than the trip is worth. Buses are equipped for riders who use wheelchairs, and the city's transportation department lists accessibility information on its transit pages.

For visitors, DASH is a less obvious but useful tool in a few districts. Downtown, the local circulators connect destinations too far to walk comfortably but too close to justify a rideshare. A visitor's transit budget for a Los Angeles weekend shows how a visitor can price a weekend of transit, and DASH rides can be added to the same TAP card.

Reading a DASH timetable

A DASH timetable is shorter and plainer than a Metro line page. It lists the route's stops in order along the top, the times at the main timepoints in columns, and separate tables for weekdays, Saturdays and Sundays. Two things trip up first-time riders. The first is the timepoint: the times printed are for a handful of major stops, and a stop between two timepoints is served some minutes after the earlier one, so you add a few minutes by eye. The second is the loop. Because a loop has no far end, the same stop can appear twice in the table, once on the way out and once as the bus comes around again, and the two times lead to very different rides. Reading the map beside the table settles which one you want.

The pages also carry a rider's guide that explains how to pay, how to request a stop and how to ask the operator for help. LADOT staff answer questions about the service, and complaints and comments can go through 311; the page reporting problems to 311: potholes, graffiti and missed pickups explains how.

When DASH is the wrong tool

DASH is no substitute for rail or for the long Metro corridors. If your trip is across the city, from the Valley to the Westside or from downtown to the harbor, a circulator is the wrong tool. It is also the wrong one when you need service at all hours. Think of it as a connector: a way to cover the first and last miles, and to move around inside a district, with Metro for the long distances in between.

The city's transportation department also handles parking enforcement and the paper side of getting around. If you are mixing modes, the pages at ladot.lacity.gov cover buses, parking and traffic, and the 311 line takes complaints about bus stops, shelters and service.

Related city government

Related guides

Related neighborhoods

Latest on this topic